CONTEGA SOLIDO SL-D
Full-surface adhesive plaster sealing tape for interior use with an additional adhesive zone on the fleece side
- The joint is immediately airtight as a result of full-surface adhesion
- Extremely strong adhesion on mineral subsurfaces too thanks to SOLID adhesive
- Can be plastered over
- Simple joints thanks to the additional adhesive zone
- Easy to apply
- Excellent values in the hazardous substance test, has been tested according to the ISO 16000 evaluation scheme
The CONTEGA SOLIDO SL-D joint adhesive tape, which is full-surface adhesive and can be plastered over, ensures interior airtight and vapour-retarding sealing of windows and doors to adjacent building components made of wood and mineral subsurfaces such as concrete and masonry.
The integrated adhesive zone on the fleece side makes it easy to seal joints to windows and doors.
The stuck joint is immediately airtight and can be subjected to loading. The fleece can simply be plastered over in accordance with our application guide.
These bonds will correspond to the requirements of DIN 4108-7, SIA 180 and OENORM B 8110-2.
|Backing||PP backing fleece, PP copolymer special membrane|
|Adhesive||modified waterproof SOLID adhesive / special acrylate adhesive|
|Release film||one or two split silicone-coated PE sheet|
|sd-value||EN 1931||2.8 m||EN 1931|
|Vapor permeance||ASTM E 96||1.17 US perms||ASTM E 96|
|Airtightness||ift, MO-01/1:2007-01, Abs. 5||up to 1000 Pa, surrounding||ift, MO-01/1:2007-01, Abs. 5|
|Requirement for bond strength, non-aged/aged||DIN 4108-11||passed||DIN 4108-11|
|Can be plastered over||yes|
|Application temperature||above -10 °C ; 14 °F|
|Temperature resistance||permanent -40 °C to 90 °C ; -40 °F to 194 °F|
|Storage||cool and dry|
The bonds should not be subjected to tensile strain.
Press firmly to secure the adhesive tapes in place. Ensure that there is sufficient resistance pressure. Airtight seals can only be achieved if the sealing tape is installed free of folds and breaks.
Ventilate continuously and systematically to prevent build-up of excessive humidity; use a dryer if necessary.
Before sticking, subsurfaces should be brushed off, wiped clean with a cloth or cleaned using compressed air.
Uneven mineral subsurfaces may need to be levelled with a smooth finish.
Adhesion to frozen surfaces is not possible. There must be no water-repellent substances (e.g. grease or silicone) on materials to be bonded. Subsurfaces must be sufficiently dry and have sufficient load-bearing capacity.
Permanent adhesion is achieved on all pro clima interior membranes and on other vapour retarder and airtight membranes (e.g. those made of PE, PA, PP and aluminium).
Adhesion can be carried out on planed and painted wood, hard plastics, hard wood-based panels (chipboard, OSB and plywood panels) and on mineral subsurfaces such as concrete and masonry.
The best results in terms of structural stability are achieved on high-quality subsurfaces.
It is your responsibility to check the suitability of the subsurface; adhesion tests are recommended in certain cases.
Pretreatment with TESCON PRIMER is recommended in the case of subsurfaces with insufficient load-bearing capacity.