ROFLEX SOLIDO
Full-surface adhesive pipe grommets that can be plastered over, for interior and exterior use
Advantages
- Keeps building components dry: quick and simple sealing
- Reliable joints thanks to water-resistant SOLID adhesive
- Practical handling: pipes can be pushed and pulled through the grommet – the joint remains sealed
- Extremely flexible and elastic, no protruding sleeve
- Construction in adherence with standards: for airtight sealing in accordance with DIN 4108-7, SIA 180 and RE 2020
- Excellent values in hazardous substance testing, has been tested according to the ISO 16000 evaluation scheme
Areas of application
For quick, permanently sealed joints for pipe feed-throughs for masonry and concrete walls and ceilings and for wood fibreboards and wood-based panels, both indoors and outdoors.
| Product | Ø grommet | For Ø pipe |
| ROFLEX SOLIDO 50 | 200 mm (7.9") | 50-80 mm (2" - 3 1/8") |
| ROFLEX SOLIDO 100 | 250 mm (~10") | 90-120 mm (3 1/2" - 4 3/4") |
| ROFLEX SOLIDO 150 | 296 mm (11 5/8") | 120-170 mm (4 3/4" - 6 3/4") |
| ROFLEX SOLIDO 200 | 346 mm (13 5/8“) | 180-220 mm (7" - 8 3/4") |
Installation instructions
Installation steps
General conditions
The bonds should not be subjected to tensile strain. Rub the adhesive tapes firmly to secure the adhesive bonds. Ensure that there is sufficient resistance pressure.
When plastering, please observe the recommendations of the plaster manufacturer for non-absorbent subsurfaces. A bonding course may be necessary. Ventilate continuously and systematically to prevent build-up of excessive humidity; use a dryer if necessary.
Substrate
Clean subsurfaces before sticking. Adhesion to frozen surfaces is not possible. There must be no water-repellent substances (e.g. grease or silicone) on materials to be bonded. Subsurfaces must be sufficiently dry and stable.
Permanent adhesion is achieved on stable mineral subsurfaces such as masonry, concrete or plaster. If the grommet is stuck to a thermal insulation composite system made of wood-fibre insulating material, for example, pre-treatment with TESCON PRIMER is necessary. In the case of rain or other wetting, the contour of ROFLEX SOLIDO may become visible due to its different water absorption/drying behaviour. Concrete or plaster subsurfaces must not be sandy or crumbling.
The best results in terms of structural stability are achieved on high-quality subsurfaces. It is your responsibility to check the suitability of the subsurface; adhesion tests are recommended in certain cases. Pre-treatment with TESCON PRIMER is recommended in the case of subsurfaces with insufficient stability.
