Intelligent window sealing tape for interior and exterior use
- Reliable installation: the same tape for interior and exterior use thanks to its intelligent functional membrane
- Extra thin: for easy folding in corner areas
- Construction in adherence with standards: for airtight bonding in accordance with DIN 4108-7, SIA 180 and RT 2012
- Reliable performance independently confirmed: bears the RAL quality mark
- Reliable joints: slack for expansion can accommodate movements by building components
- Fleece side can be plastered over: defined transition between window joints and plaster
- Excellent values in the hazardous substance test, has been tested according to the ISO 16000 evaluation scheme
Areas of Application
For interior airtight joints between windows or doors and the vapour retarder and airtight layers.
Thanks to its intelligent, humidity-variable functional membrane, CONTEGA IQ is also suitable for exterior windproof and rainproof joints.
The tape has slack for expansion to allow for relative motion between components.
ID 12941 - CONTEGA IQ with 1 self-adhesive strip for use with masonry or concrete structures
ID 13016 - CONTEGA IQ with 2 self-adhesive strips for use with timber structures
Photo gallery - Installation: 1. Timber frame construction, interior
Photo gallery - Installation: 2. Timber frame construction, exterior
Photo gallery - Installation: 3. Masonry construction, interior
Photo gallery - Installation: 4. Masonry construction, exterior
The bonds should not be subjected to tensile strain.
Press firmly to secure the adhesive tapes in place. Ensure that there is sufficient resistance pressure.
Driving rainproof and wind- or airtight seals can only be achieved if this connection tape is laid without folds or creases and are uninterrupted.
Ventilate continuously and systematically to prevent build-up of excessive humidity; use a dryer if necessary.
When plastering, please observe the recommendations of the plaster manufacturer for non-absorbent subsurfaces. A bonding course may be necessary.
Clean subsurfaces before sticking.
Adhesion to frozen surfaces is not possible. There must be no water-repellent substances (e.g. grease or silicone) on materials to be bonded.
The width of the adhesive tape that is to be plastered over should generally not exceed 60 mm (2 3/8") or 50% of the soffit area. Detailed recommendations can be obtained from the relevant plaster producer.
Subsurfaces must be sufficiently dry and stable.
Permanent adhesion is achieved on all pro clima interior and exterior membranes, other vapour retarder and airtight membranes (e.g. those made of PE, PA, PP and aluminium) as well as other roof and wall lining membranes (e.g. those made of PP and PET).
Adhesion can be carried out on planed and painted wood, hard plastics, hard wood-based panels (chipboard, OSB and plywood panels).
For bonding joints on masonry or concrete or on rough substrates, use ORCON F.
The best results in terms of structural stability are achieved on high-quality subsurfaces.
It is your responsibility to check the suitability of the subsurface; adhesion tests are recommended in certain cases.
Pretreatment with TESCON PRIMER is recommended in the case of subsurfaces with insufficient stability.
The slack included for expansion automatically becomes active if there is relative motion between building
components and provides increased protection against tearing.
CONTEGA IQ thus provides optimal protection against leaks that could lead to damage to structures and mould.