Rolls of joint adhesive for interior and exterior use


  • Subsequent work can be started quickly: joint adhesive from a roll, no drying time - joint can be subjected to loading immediately
  • Can be used flexibly: sticks in a permanent, reliable manner thanks to water resistant SOLID adhesive
  • Reliable even during frosty conditions: sticks reliably above –15 °C
  • Construction in adherence with standards: for airtight bonding in accordance with DIN 4108-7, SIA 180 and RT 2012
  • Excellent values in hazardous substance testing, has been tested according to the ISO 16000 evaluation scheme

Areas of application

Solvent-free, permanent, elastic, frost-resistant airtight adhesive that can be applied straight from a roll for bonding all types of vapour checks and vapour barriers – e.g. pro clima INTELLO, INTELLO X, DB+, DASATOP and DA, as well as PE, PA, PP or aluminium sheeting – on mineral or rough adjacent components such as masonry, plasterwork, concrete or roughly sawn wood.

Sticking of windtight joints on commercially available roof underlays (e.g. those made of PE and PET). Joint adhesion in combination with the pro clima SOLITEX MENTO family of products and SOLITEX UM fulfils the requirements of the ZVDH product data sheets.

Windtight sticking of wall-lining membranes of all types (e.g. pro clima SOLITEX FRONTA family).

Installation instructions

General conditions

The bonds must not be subjected to tensile forces. It may be advisable to use mechanical reinforcements. Rub the bond firmly into place (e.g. using the pro clima PRESSFIX application tool). The product achieves its final level of strength after approx. 24 h.


Clean subsurfaces before sticking.Mineral surfaces (plaster or concrete) may be slightly moist. Adhesion to frozen surfaces is not possible. The substrate material must be free of water-repellent substances (e.g. grease or silicone). Subsurfaces must be stable - if necessary, a mechanical support (pressure lath) must be used (e.g. on crumbling subsurfaces).

Permanent adhesion is achieved on all pro clima interior and exterior membranes, other vapour-check and airtight membranes (e.g. those made of PE, PA, PP and aluminium) as well as other roof and wall lining membranes (e.g. those made of PP and PET). Bonds can be created on mineral subsurfaces (e.g. plaster or concrete), roughly sawn, planed and painted wood, hard plastics and rustproof metal (e.g. pipes, windows etc.) and hard wood-based panels (chipboard, OSB, plywood, MDF panels).

The best results in terms of structural stability are achieved on high-quality subsurfaces. It is your responsibility to check the suitability of the subsurface; adhesion tests are recommended in certain cases. Pretreatment with TESCON PRIMER is recommended in the case of subsurfaces with insufficient stability.