Corner adhesive tape with two separate removable release strips

 

Advantages

  • Corner adhesive tape for internal and external use, 6 months of outdoor exposure
  • Two individually removable strips of release paper
  • Very elastic, soft and permanently deformable (no self-alignment), also ideal for connecting to penetrations
  • Airtight bonds according to DIN 4108-7, SIA 180 and OENORM B 8110-2
  • Waterproof adhesive
  • Excellent values in the hazardous substance test, has been tested according to the ISO 16000 evaluation scheme
  • Can be plastered over
 

Application

Corner sealing of airtightness or windtightness layers, e.g. on windows and doors, as well as other corner joints on structures, indoors or outdoors, including joints between roof and wall installations on sarking membrane, roof lining membrane or wall lining membrane.
The bonds meet the requirements of DIN 4108-7, SIA 180 and OENORM B 8110-2 as well as bonding to wood-based panels.

  Material
Backing special PP fleece
Adhesive waterproof SOLID adhesive
Release film split silicone coated PE-film approx. 12 / 48 mm
Attribute Value Norm
Colour light blue
Exposure time 6 months
Application temperature above -10 °C ; 14 °F
Temperature resistance permanent -40 °C to 90 °C ; -40 °F to 194 °F
Storage cool and dry

General conditions

The bonds should not be subjected to tensile strain.
Once membranes have been stuck, the weight of the insulation material must be supported by laths. Adhesion should be supported by additional laths, if necessary.
Press firmly to secure the adhesive tapes in place. Ensure that there is sufficient resistance pressure.
Windproof, airtight or rainproof bonding can only be achieved on vapour retarders or underlay/sarking/facade membranes that have been laid without folds or creases.
Ventilate continuously and systematically to prevent build-up of excessive humidity; use a dryer if necessary.

Substrate

Before sticking, subsurfaces should be brushed off, wiped clean with a cloth or cleaned using compressed air.
Bonding to frozen surfaces is not possible. The substrate material must be free of water-repellent substances (e.g. grease or silicone). Subsurfaces must be sufficiently dry and have sufficient load-bearing capacity.

Permanent adhesion is achieved on all pro clima interior and exterior membranes, other vapour retarder and airtight membranes (e.g. those made of PE, PA, PP and aluminium) as well as other underlay/sarking and wall lining membranes (e.g. those made of PP and PET).
Adhesion and joints can be carried out on planed and painted wood, hard plastics and metal (e.g. pipes, windows etc.), hard wood-based panels (chipboard, OSB and plywood panels, MDF board and softwood fibre sub-roof panels).
Wood fibre sub-roof panels and smooth mineral subsurfaces require pre-treatment with TESCON PRIMER before bonding. Concrete or plaster subsurfaces must not be sandy or crumbling.

The best results in terms of structural stability are achieved on high-quality subsurfaces.
It is your responsibility to check the suitability of the subsurface; adhesion tests are recommended in certain cases.
Pretreatment with TESCON PRIMER is recommended in the case of subsurfaces with insufficient load-bearing capacity.