ROFLEX SOLIDO
Installation steps
1. Pull the grommet over the pipe
Pull the grommet over the open end of the pipe.
If the selected grommet is too tight for the pipe: grip the inside of the opening from either side with your two hands and pull on it firmly; this should stretch the backing fleece.
1. Pull the grommet over the pipe
Pull the grommet over the open end of the pipe.
If the selected grommet is too tight for the pipe: grip the inside of the opening from either side with your two hands and pull on it firmly; this should stretch the backing fleece.
2. Position the grommet
Hold the grommet using the EPDM sealing ring, slide the grommet along the pipe using moderate force and position it on the wall.
2. Position the grommet
Hold the grommet using the EPDM sealing ring, slide the grommet along the pipe using moderate force and position it on the wall.
3. Stick to the subsurface
Gradually remove the release film and stick the grommet to the subsurface with no folds or creases. Wood fibre should be treated with TESCON PRIMER.
3. Stick to the subsurface
Gradually remove the release film and stick the grommet to the subsurface with no folds or creases. Wood fibre should be treated with TESCON PRIMER.
4. Rub to secure the adhesive bond
Rub the adhesive bond evenly and firmly into place. This step can be carried out in a manner that is kinder to your hands by using the PRESSFIX application tool.
4. Rub to secure the adhesive bond
Rub the adhesive bond evenly and firmly into place. This step can be carried out in a manner that is kinder to your hands by using the PRESSFIX application tool.
5. Plaster over the grommet
Plaster over the entire surface of the grommet using suitable plastering systems.
5. Plaster over the grommet
Plaster over the entire surface of the grommet using suitable plastering systems.