AEROSANA VISCONN FIBRE white
Sealing wall-to-floor joints with AEROFIXX
1. Preparation
Brush off subsurfaces; if necessary, clean with a vacuum cleaner and wipe down.
1. Preparation
Brush off subsurfaces; if necessary, clean with a vacuum cleaner and wipe down.
2. Preparation of taped joints between boards, if required
If the gaps between adjacent wood-based panels have been taped using TESCON RAPIC to create airtight seals, this tape should be covered over with short lengths of TESCON VANA in the area close to the floor where a liquid sealant will be applied. The edges of the TESCON VANA must adhere directly onto the wood-based panel here.
2. Preparation of taped joints between boards, if required
If the gaps between adjacent wood-based panels have been taped using TESCON RAPIC to create airtight seals, this tape should be covered over with short lengths of TESCON VANA in the area close to the floor where a liquid sealant will be applied. The edges of the TESCON VANA must adhere directly onto the wood-based panel here.
3. Spray setting
Set the AEROFIXX to spray application.
3. Spray setting
Set the AEROFIXX to spray application.
4. Spray over the base joint
Spray the wall-to-floor joint area. Apply the sealant to a width of at least 30 mm (1 3/16") on the surfaces to be sealed.
The layer thickness is sufficient when a textured surface (‘orange peel’) is recognisable.
4. Spray over the base joint
Spray the wall-to-floor joint area. Apply the sealant to a width of at least 30 mm (1 3/16") on the surfaces to be sealed.
The layer thickness is sufficient when a textured surface (‘orange peel’) is recognisable.