Joints at double collar ties with AEROFIXX
1. Initial situation
2. Preparation
Brush off subsurfaces; if necessary, clean with a vacuum cleaner and wipe down.
3. Check the joint width
Gaps of up to 3 mm can be filled using AEROSANA VISCONN. Use AEROSANA VISCONN FIBRE for wide gaps of up to 20 mm (3/4"). In this case, the gap must be filled with sealant to a depth of at least half the width of the gap.
4. Set the device
Set the AEROFIXX to line application.
5. Fill the joint
Fill the joint with a sufficient amount of AEROSANA VISCONN / FIBRE.
6. Spray over the joint
Set the AEROFIXX to spray application and spray over the joint in a generous manner.
Apply the sealant to a width of at least 30 mm (1 1/4") on the surfaces to be sealed. The layer thickness is sufficient when a textured surface (‘orange peel’) is recognisable.
7. Work on detail features
Areas that are difficult to access can also be sealed conveniently using the spray method.
8. Check the joint
If necessary, seal any gaps with a brush and AEROSANA VISCONN / FIBRE.