Window-sealing, airless
1. Cut away protruding foam
Insert the insulating material (loose wool, loose hemp) into the window joint in such a way that is flush with the window frame.
Cut away protruding foam after it has hardened.
2. Clean the subsurface
3. Protect the window with sheeting
Protect the panes of glass and visible parts of the frame against soiling by using masking tape.
4. Spray the lintel and reveals
Apply the required layer thickness of AEROSANA VISCONN in one or two spraying steps.
5. Check the layer thickness
Check the required wet layer thickness of 500 μm using a suitable gauge.
6. Pre-spray the sub-sill flashing
AEROSANA VISCONN is also suitable for use in forming sub-sill flashing.
To do this, first spray the insulation angle fillet in a generous manner.
7. Install the AEROSANA FLEECE sub-sill flashing
Insert the AEROSANA FLEECE into the still-wet AEROSANA VISCONN spray film, ensuring there are no folds or creases.
Carefully finish any corners or raised edges.
8. Spray over AEROSANA FLEECE
The AEROSANA FLEECE is embedded in place by spraying again with AEROSANA VISCONN.
9. Remove the protective sheeting
Remove the stuck-on protective sheeting before AEROSANA VISCONN dries.