Full-surface adhesive plaster sealing tape for exterior use that is open to diffusion

 

Advantages

  • Full-surface adhesive, the joint is immediately windproof and resistant to driving rain, and it can be subjected to loading
  • Extremely strong adhesion on mineral subsurfaces too thanks to modified waterproof SOLID adhesive
  • Can be plastered over
  • Tape for joints on or under window frames
  • Easy to apply
 

Application

The CONTEGA SOLIDO EXO joint adhesive tape, which is full-surface adhesive and can be plastered over, ensures exterior windtight and diffusion-permeable sealing of windows and doors to adjacent building components made of wood and mineral materials such as concrete and sand-lime brick.
The modified waterproof SOLID adhesive ensures quick and permanent adhesion to the subsurface.
The stuck joint is immediately windproof and can be subjected to loading. The fleece can simply be plastered over in accordance with our application guide.

  Material
Backing PP backing fleece, PP copolymer special membrane
Adhesive modified waterproof SOLID adhesive
Release film one or two split silicone-coated PE sheet
Attribute Value Norm
Colour black
sd-value 0.7 m EN 1931
g-value 3.5 MN⋅s/g
Vapor permeance 4.7 US perms ASTM E 96
Exposure time 3 months
Water column > 2 500 mm ; > 8' 2" EN 20811
Resistance to driving rain up to 600 Pa, surrounding ift, MO-01/1:2007-01, Abs. 5
Can be plastered over yes
Application temperature above -10 °C ; 14 °F
Temperature resistance permanent -40 °C to 90 °C ; -40 °F to 194 °F
Storage cool and dry

General conditions

The bonds should not be subjected to tensile strain.
Press firmly to secure the adhesive tape. Ensure there is sufficient back-pressure.
Driving rainproof and windtight seals can only be achieved if this connection tape is laid without folds or creases and are uninterrupted.

Substrate

Before sticking, subsurfaces should be brushed off, wiped clean with a cloth or cleaned using compressed air.
Uneven mineral subsurfaces may need to be levelled with a smooth finish.
Bonding to frozen surfaces is not possible. There must be no water-repellent substances (e.g. grease or silicone) on materials to be bonded. Subsurfaces must be sufficiently dry and have sufficient load-bearing capacity.

Permanent adhesion is achieved on all pro clima interior membranes and on other vapour retarder and airtight membranes (e.g. those made of PE, PA, PP and aluminium). Adhesion can be carried out on planed and painted wood, hard plastics, hard wood-based panels (chipboard, OSB and plywood panels) and on mineral subsurfaces such as concrete and masonry.

The best results in terms of structural stability are achieved on high-quality subsurfaces.
It is your responsibility to check the suitability of the subsurface; adhesion tests are recommended in certain cases.
Pretreatment with TESCON PRIMER is recommended in the case of subsurfaces with insufficient load-bearing capacity.