AEROSANA VISCONN white

1. Cut away protruding foam

Insert the insulating material (loose wool, loose hemp) into the window joint in such a way that is flush with the window frame.
Cut away protruding foam after it has hardened.

2. Clean the subsurface

3. Protect the window with sheeting

Protect the panes of glass and visible parts of the frame against soiling by using masking tape.

4. Spray the lintel and reveals

Apply the required layer thickness of AEROSANA VISCONN in one or two spraying steps.

5. Check the layer thickness

Check the required wet layer thickness of 500 μm using a suitable gauge.

6. Pre-spray the sub-sill flashing

AEROSANA VISCONN is also suitable for use in forming sub-sill flashing.
To do this, first spray the insulation angle fillet in a generous manner.

7. Install the AEROSANA FLEECE sub-sill flashing

Insert the AEROSANA FLEECE into the still-wet AEROSANA VISCONN spray film, ensuring there are no folds or creases.
Carefully finish any corners or raised edges.

8. Spray over AEROSANA FLEECE

The AEROSANA FLEECE is embedded in place by spraying again with AEROSANA VISCONN.

9. Remove the protective sheeting

Remove the stuck-on protective sheeting before AEROSANA VISCONN dries.