Installation steps: 1. Before the window is installed
![1. Masonry structures](/media/product_galleries/18384.jpg.555x345_q85.jpg)
1. Masonry structures
CONTEGA SOLIDO SL is to be applied before the window is installed. The frame is laid out flat with the interior side facing up.
1. Masonry structures
CONTEGA SOLIDO SL is to be applied before the window is installed. The frame is laid out flat with the interior side facing up.
![2. Stick to the side of the frame](/media/product_galleries/10548.jpg.555x345_q85.jpg)
2. Stick to the side of the frame
Remove the narrow release film strip, position the tape on the side of the frame flush with the frame edge and then gradually stick it in place. The fleece side of the tape must be facing outwards here.
2. Stick to the side of the frame
Remove the narrow release film strip, position the tape on the side of the frame flush with the frame edge and then gradually stick it in place. The fleece side of the tape must be facing outwards here.
![3. Preparation of corners](/media/product_galleries/18385.jpg.555x345_q85.jpg)
3. Preparation of corners
Fold CONTEGA SOLIDO SL in the corner areas as shown. Remove the narrow release film and stick the tapes to one another. Ensure that there is uninterrupted airtightness when sticking the tapes together.
3. Preparation of corners
Fold CONTEGA SOLIDO SL in the corner areas as shown. Remove the narrow release film and stick the tapes to one another. Ensure that there is uninterrupted airtightness when sticking the tapes together.
![4. Stick the tape all around the window frame](/media/product_galleries/18386.jpg.555x345_q85.jpg)
4. Stick the tape all around the window frame
Stick the tape to the side of the frame all around. When finished, cut the tape, allowing approx. 5 cm (2") of an overlap, and stick this over the other end of the tape. Rub firmly using the pro clima PRESSFIX application tool to secure the adhesive bond.
4. Stick the tape all around the window frame
Stick the tape to the side of the frame all around. When finished, cut the tape, allowing approx. 5 cm (2") of an overlap, and stick this over the other end of the tape. Rub firmly using the pro clima PRESSFIX application tool to secure the adhesive bond.
![5. Install the window and insulate the joint](/media/product_galleries/18387.jpg.555x345_q85.jpg)
5. Install the window and insulate the joint
Fold in the CONTEGA SOLIDO SL and install the window professionally. Use a suitable fastening system. Fill in the joint with a suitable approved insulation material, leaving no cavities.
5. Install the window and insulate the joint
Fold in the CONTEGA SOLIDO SL and install the window professionally. Use a suitable fastening system. Fill in the joint with a suitable approved insulation material, leaving no cavities.
![6. Stick onto the reveal and rub into place](/media/product_galleries/18388.jpg.555x345_q85.jpg)
6. Stick onto the reveal and rub into place
Remove the wide release film strip and gradually stick the tape in place all around the reveal. Rub firmly using the pro clima PRESSFIX application tool to secure the adhesive bond.
6. Stick onto the reveal and rub into place
Remove the wide release film strip and gradually stick the tape in place all around the reveal. Rub firmly using the pro clima PRESSFIX application tool to secure the adhesive bond.